Home > Knowledge > Content

Stacking Principle of T-shaped Ductile Iron Pipe Fittings

Feb 06, 2023

1. The principle of stacking ductile iron pipe fittings is to stack according to varieties and specifications under stable stacking conditions, and different kinds of materials should be stacked separately to prevent confusion and mutual corrosion.

2. It is forbidden to store articles corrosive to steel near the stacking position.

3. The bottom of the stack shall be raised and leveled to prevent the material from moisture or deformation.

4. The same materials shall be stacked separately according to the warehousing order to facilitate the implementation of the principle of first delivery.

5. For the ductile iron pipe fittings stacked in the open air, there should be wooden mat or strip stone below, and the stacking surface should be slightly inclined to facilitate drainage, and the materials should be placed straight to prevent bending and deformation.

6. The stacking height of ductile iron pipe fittings shall not exceed 1.2m for manual operation, 1.5m for mechanical operation and 2.5m for stacking width.

7. There shall be a passage between stacks. The inspection passage is generally 0.5m, and the access passage depends on the size of materials and transportation machinery, generally 1.5~2.0m.

8. The height of the pile bottom is 0.1m if the warehouse is a cement floor in Chaoyang; If it is muddy ground, it must be raised by 0.2~0.5m; If it is an open field, the cement ground shall be 0.3~0.5m high and the sand and mud surface shall be 0.5~0.7m high.

Send Inquiry